Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › OCCUPANT CLASSIFICATION SYSTEM

OCCUPANT CLASSIFICATION SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the occupant classification system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.PASSENGER AIRBAG ON/OFF INDICATOR CHECK

      NEXT


      3.DTC CHECK (Present and Past DTC)*
      1. Check for DTCs (Click here).

        Result:
        Result
        Proceed to
        DTC is output.
        A
        DTC is not output.
        B



      B.
      GO TO PROBLEM SYMPTOMS TABLE
      A


      4.DTC CHART

        NEXT


        5.REPAIR OR REPLACEMENT

          NEXT


          6.DTC CLEARANCE (Present and Past DTCs)*
          1. Clear the DTCs (Click here).


          NEXT


          7.DTC CHECK (Present and Past DTCs)*
          1. Check for DTCs (Click here).

            Result:
            Result
            Proceed to
            DTC is not output.
            A
            DTC is output.
            B



          B.
          Go to step 5
          A


          8.PROBLEM SYMPTOMS SIMULATION
          1. Check the passenger airbag ON/OFF indicator condition (Click here).

            Result:

            Result
            Proceed to
            Passenger airbag ON/OFF indicator is operating normally.
            A
            Passenger airbag ON/OFF indicator (OFF) is not operating normally.
            B



          B.
          Go to step 5
          A


          9.CONFIRMATION TEST

            NEXT

            END