NAVIGATION SYSTEM > Navigation ECU Power Source Circuit |

| 1.INSPECT FUSE (DOME, ACC) |
Disconnect the DOME fuse from the engine room junction block.
Disconnect the ACC fuse from the driver side junction block.
Measure the resistance of the fuses.
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (NAVIGATION ECU - BATTERY AND BODY GROUND) |
![]() |
Disconnect the N3 ECU connector.
Measure the voltage and resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| N3-1 (+B) - Body ground | Always | 10 to 14 V |
| N3-13 (ACC) - Body ground | Power switch ON (ACC) | 10 to 14 V |
| Tester Connection | Specified Condition |
| N3-15 (GND1) - Body ground | Below 1 Ω |
|
| ||||
| OK | ||
| ||