Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Multi-display Power Source Circuit

for Preparation Click here


DESCRIPTION

The circuit provides power to the multi-display.

WIRING DIAGRAM


E126437E02


INSPECTION PROCEDURE

1.INSPECT FUSE (ACC, ECU-B, ECU-IG)
  1. Disconnect the ACC, ECU-B and ECU-IG fuses from the driver side junction block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (MULTI-DISPLAY - BATTERY AND BODY GROUND)


    B122460E08
  1. Disconnect the M13 display connector.

  1. Measure the resistance and voltage of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    M13-1 (GND1) - Body ground
    Below 1 Ω
    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    M13-3 (+B1) - Body ground
    Always
    10 to 14 V
    M13-2 (ACC) - Body ground
    Power switch ON (ACC)
    10 to 14 V
    M13-10 (IG) - Body ground
    Power switch ON (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE