Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Reverse Signal Circuit

for Preparation Click here


DESCRIPTION

The navigation ECU receives a reverse signal from the BK/UP LP relay and information about the GPS antenna, and then adjusts vehicle position.

WIRING DIAGRAM


E126421E01


INSPECTION PROCEDURE

1.CHECK BACK-UP LIGHT
  1. Move the shift lever to the R position and check if the back-up lights turn on.

    OK:
    The back-up lights turn on.



NG
GO TO LIGHTING SYSTEM
OK


2.CHECK WIRE HARNESS (BK/UP LP RELAY - NAVIGATION ECU AND BODY GROUND)


    E126444E01
  1. Disconnect the N3 ECU connector.

  1. Disconnect the 3H engine room relay block connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    N3-20 (REV) - 3H-8
    Below 1 Ω
    N3-20 (REV) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE NAVIGATION ECU