Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Navigation Voice Speaker Circuit

for Preparation Click here


DESCRIPTION

This circuit is used when the voice guidance in the navigation system is on.

WIRING DIAGRAM


E126488E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (MULTI-DISPLAY - NAVIGATION ECU)


    E126448E02
  1. Disconnect the M14 display connector.

  1. Disconnect the N3 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    N3-8 (VOI-) - M14-6 (IVI-)
    Below 1 Ω
    N3-9 (VOI+) - M14-5 (IVI+)
    Below 1 Ω
    N3-8 (VOI-) - Body ground
    10 kΩ or higher
    N3-9 (VOI+) - Body ground
    10 kΩ or higher



NG
PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
OK


2.CHECK WIRE HARNESS (MULTI-DISPLAY - STEREO COMPONENT AMPLIFIER)


    E126443E03
  1. Disconnect the M14 display connector.

  1. Disconnect the S15 amplifier connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    M14-25 (IVO+) - S15-23 (INT+)
    Below 1 Ω
    M14-26 (IVO-) - S15-22 (INT-)
    Below 1 Ω
    M14-25 (IVO+) - Body ground
    10 kΩ or higher
    M14-26 (IVO-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE