Home › RESTRAINTS › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the RH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
  1. Install the belt anchor adjuster with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH
  1. Install the outer belt to the center pillar with the 2 bolts.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf } for upper bolt
    42 N*m{ 428 kgf*cm , 31 ft.*lbf } for lower bolt



    B074546E01
  1. Connect the pretensioner connector as shown in the illustration.

  1. Install the outer belt with the bolt on the shoulder anchor side.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Install the shoulder anchor cover.

  1. Install the outer belt with the bolt on the floor anchor side.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Install the center pillar garnish RH .

  1. Install the center pillar lower garnish RH .

  1. Install the floor anchor to the floor panel with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. Install the front door scuff plate RH .

  1. Install the rear door scuff plate RH .

  1. Install the front door opening trim weatherstrip RH .

  1. Install the rear door opening trim weatherstrip RH .

  1. Check if the ELR locks.

    NOTICE:
    The check should be performed with the outer belt assembly installed.


    1. With the belt installed, check that the belt locks when it is pulled out quickly.
      If the operation is not as specified, replace the outer belt assembly.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.