Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the RH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE FRONT SEAT ASSEMBLY RH
  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.

  1. Remove the 2 bolts on the front side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.

  1. Remove the 2 bolts on the rear side of the seat.

  1. Disconnect the connectors under the seat. Then remove the front seat.

    NOTICE:
    Be careful not to damage the vehicle body.



3. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH
  1. Remove the bolt and inner belt.