Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM


E107218E06


INSPECTION PROCEDURE

1.INSPECT FUSE (DOME, ACC)
  1. Disconnect the DOME fuse from the engine room junction block.

  1. Disconnect the ACC fuse from the driver side junction block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (RECEIVER - BATTERY AND BODY GROUND)


    E129162E03
  1. Disconnect the R3*1 or R6*2 receiver connector.

    HINT:
    1. *1: for 6 speaker system
    2. *2: for 9 speaker system

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    R3-7 (GND) - Body ground*1
    Below 1 Ω
    R6-20 (GND) - Body ground*2

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    R3-4 (+B) - R3-7 (GND)*1
    Always
    10 to 14 V
    R6-1 (B) - R6-20 (GND)*2
    R3-3 (ACC) - R3-7 (GND)*1
    Power switch ON (ACC)
    10 to 14 V
    R6-11 (ACC) - R6-20 (GND)*2



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE