Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Stereo Component Amplifier Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the stereo component amplifier.

WIRING DIAGRAM


E107219E01


INSPECTION PROCEDURE

1.INSPECT FUSE (AMP, ACC)
  1. Disconnect the AMP fuse from the engine room junction block.

  1. Disconnect the ACC fuse from the driver side junction block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (AMPLIFIER - BATTERY AND BODY GROUND)


    E107220E02
  1. Disconnect the S14, S15 and S29 amplifier connectors.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester Connection
    Specified Condition
    S29-6 (GND) - Body ground
    Below 1 Ω
    S29-7 (GND2) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connectors.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    S14-1 (+B) - S29-6 (GND)
    Always
    10 to 14 V
    S14-5 (+B2) - S29-6 (GND)
    Always
    10 to 14 V
    S15-12 (ACC) - S29-6 (GND)
    Power switch ON (ACC)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE