Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Broadcast cannot be Received or Poor Reception

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK RADIO RECEIVER
  1. Check the radio's automatic station search function.

    1. Move the vehicle to a location where radio wave reception is possible.

    2. Check the radio's automatic station search function by activating it.

      OK:
      The radio's automatic station search function works properly.



OK
REPLACE RADIO RECEIVER
NG


2.CHECK RADIO RECEIVER


    E107233E01
  1. Disconnect the R3*1 or R6*2 receiver connector.

  1. Measure the voltage of the receiver.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    R3-8 (ANT+) - Body ground*1
    Power switch ON (IG),
    Radio switch ON
    10 to 14 V
    R6-13 (ANT+) - Body ground*2

    HINT:
    1. *1: for 6 speaker system
    2. *2: for 9 speaker system



NG
REPLACE RADIO RECEIVER
OK


3.CHECK OPTIONAL COMPONENTS
  1. Check optional components (sunshade film, telephone antenna, etc.).

    1. Check if any optional components, such as sunshade film or telephone antenna, that may decrease reception capacity are installed.

      OK:
      Optional components are installed.

      NOTICE:
      Do not remove any optional components installed by the customer without consent.



OK
REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)
NG


4.CHECK RADIO RECEIVER


    E050367
  1. Preparation for check

    1. Remove the antenna plug from the radio receiver.

  1. Check for noise

    1. Turn the power switch ON (ACC) with the radio receiver connector connected.

    2. Turn the radio on and change to AM mode.

    3. Place a screwdriver, thin wire, or other metal object on the radio receiver's antenna jack and check that noise can be heard from the speaker.

      OK:
      Noise occurs.



NG
REPLACE RADIO RECEIVER
OK


5.CHECK ANTENNA CORD
  1. Remove the antenna plug of the radio receiver and antenna.

  1. Measure the resistance between the antenna cord's inner conductor and radio receiver to check for an open circuit in the antenna cord.

    Standard resistance:
    Below 1 Ω

  1. Measure the resistance between the antenna cord's inner conductor and body ground to check for a short circuit in the antenna cord.

    Standard resistance:
    10 kΩ or higher



NG
REPLACE ANTENNA CORD
OK


6.REPLACE AMPLIFIER ANTENNA
  1. Replace the amplifier antenna and check if radio broadcasts can be received normally.

    OK:
    Radio broadcasts can be received.



OK
END
NG

REPLACE RADIO RECEIVER