Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Illumination for Panel Switch does not Come on with Tail Switch ON

for Preparation Click here


INSPECTION PROCEDURE

1.INSPECT NIGHTTIME ILLUMINATION
  1. Turn on the light control switch and check the nighttime illumination of the vehicle interior.
    Result: 
    Result
    Proceed to
    Only multi-display nighttime illumination does not operate
    A
    No nighttime illumination at all
    B



B
GO TO LIGHTING SYSTEM
A


2.CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)


    E120054E01
  1. Enter the "Display Check" mode (Vehicle Signal Check Mode) (Click here).

  1. Check that the display changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch
    Display
    TAIL or ON
    ON
    OFF
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.



OK
REPLACE MULTI-DISPLAY
NG

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE