Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK TELEVISION CAMERA ASSEMBLY

E126420E03

  1. Disconnect the T13 camera connector.

  2. Measure the voltage and resistance between each terminal of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    CGND (T13-3) - Body ground
    W - Body ground
    Ground
    Always
    Below 1 Ω
    CB+ (T13-4) - CGND (T13-3)
    B - W
    Power source
    Power switch ON (IG), shift lever R position
    Approx. 6 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the T13 camera connector.

  4. Measure the voltage and frequency between each terminal of the connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    CV+ (T13-2) - CV- (T131)
    R - Shielded
    Display signal
    Power switch ON (IG), shift lever R position
    See waveform 1
    If the result is not as specified, the camera may have a malfunction.



  5. E119731E01
  6. Using an oscilloscope, check the waveform
    Waveform 1 
    Item
    Content
    Symbols (Terminal No.)
    CV+ (T13-2) - CV- (T13-1)
    Tool Setting
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Power switch ON (IG), shift lever R position


CHECK MULTI-DISPLAY (Click here)