Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Gateway ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit to operate the gateway ECU.

WIRING DIAGRAM


E107221E01


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-IG, ACC, ECU-B)
  1. Disconnect the ECU-IG, ECU-B and ACC fuses from the driver side junction block.

  1. Measure the resistance of the fuses.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK WIRE HARNESS (GATEWAY ECU - BATTERY AND BODY GROUND)


    E107222E02
  1. Disconnect the G1 ECU connector.

  1. Measure the resistance of the wire harness side connector.

    Standard resistance:
    Tester connection
    Specified condition
    G1-24 (GND) - Body ground
    Below 1 Ω

  1. Measure the voltage of the wire harness side connector.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    G1-10 (BATT) - G1-24 (GND)
    Always
    10 to 14 V
    G1-2 (ACC) - G1-24 (GND)
    Power switch ON (ACC)
    10 to 14 V
    G1-1 (IG) - G1-24 (GND)
    Power switch ON (IG)
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE