AUDIO AND VISUAL SYSTEM > Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer on the combination meter is normal.
|
| ||||
| OK | |
| 2.CHECK STEREO COMPONENT AMPLIFIER |
![]() |
Disconnect the S15 amplifier connector.
Measure the voltage.
Jack up either one of the drive wheels.
Move the shift lever to the neutral position.
Turn the power switch ON (IG).
![]() |
Measure the voltage between terminal 11 (SPD) of the stereo component amplifier and body ground when the drive wheels are turned slowly.
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (COMBINATION METER - STEREO COMPONENT AMPLIFIER) |
![]() |
Disconnect the S15 amplifier connector.
Disconnect the C10 meter connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| S15-11 (SPD) - C10-13 | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK WIRE HARNESS (STEREO COMPONENT AMPLIFIER - BODY GROUND) |
![]() |
Disconnect the S15 amplifier connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| S15-11 (SPD) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||