Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

The radio receiver sends a sound signal to the stereo component amplifier through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier or speakers.

WIRING DIAGRAM


E107198E01


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)


    E107199E01
  1. Disconnect the R6 receiver connector.

  1. Disconnect the S15 amplifier connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    R6-9 (L+) - S15-3 (L+)
    Below 1 Ω
    R6-19 (L-) - S15-2 (L-)
    Below 1 Ω
    R6-8 (R+) - S15-5 (R+)
    Below 1 Ω
    R6-18 (R-) - S15-4 (R-)
    Below 1 Ω
    R6-9 (L+) - Body ground
    10 kΩ or higher
    R6-19 (L-) - Body ground
    10 kΩ or higher
    R6-8 (R+) - Body ground
    10 kΩ or higher
    R6-18 (R-) - Body ground
    10 kΩ or higher
    R6-10 (SLD) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE