Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

This circuit sends a signal to the stereo component amplifier to mute noise. As a reslut, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier is normal, no sound, or only an extremely small sound can be produced.

WIRING DIAGRAM


E107202E01


INSPECTION PROCEDURE

1.CHECK STEREO COMPONENT AMPLIFIER (MUTE VOLTAGE)


    E107229E01
  1. Measure the voltage of the amplifier.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    S15-1 (MUTE) - Body ground
    Turn power switch ON (ACC), Audio system is playing → Changing mode
    Above 3.5 V → Below 1 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK WIRE HARNESS (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)


    E107199E02
  1. Disconnect the R6 receiver connector.

  1. Disconnect the S15 amplifier connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    R6-7 (MUTE) - S15-1 (MUTE)
    Below 1 Ω
    R6-7 (MUTE) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK


3.REPLACE RADIO RECEIVER
  1. Replace the radio receiver with a normal one and check if it operates normally.

    OK:
    The radio receiver operates normally.



NG
REPLACE STEREO COMPONENT AMPLIFIER
OK

END