Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Microphone Circuit between Multi-display and Navigation ECU

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the multi-display to the navigation ECU.

WIRING DIAGRAM


E126445E02


INSPECTION PROCEDURE

1.CHECK WIRE HARNESS (MULTI-DISPLAY - NAVIGATION ECU)


    E126446E02
  1. Disconnect the M14 display connector.

  1. Disconnect the N4 ECU connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    M14-22 (MCO+) - N4-3 (MIC+)
    Below 1 Ω
    M14-23 (MCO-) - N4-5 (MIC-)
    Below 1 Ω
    M14-22 (MCO+) - Body ground
    10 kΩ or higher
    M14-23 (MCO-) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE