Home › BODY › MIRROR › OUTER REAR VIEW MIRROR

OUTER REAR VIEW MIRROR > INSPECTION

for Preparation Click here



1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH


B070997E04
  1. Disconnect the mirror connector.

  1. Apply battery voltage and check the operation of the mirror.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 5 (MV)
    Battery negative (-) → Terminal 4 (M+)
    Turns upward (A)
    Battery positive (+) → Terminal 4 (M+)
    Battery negative (-) → Terminal 5 (MV)
    Turns downward (B)
    Battery positive (+) → Terminal 3 (MH)
    Battery negative (-) → Terminal 4 (M+)
    Turns left (C)
    Battery positive (+) → Terminal 4 (M+)
    Battery negative (-) → Terminal 3 (MH)
    Turns right (D)

    If the result is not as specified, replace the mirror assembly.



    B076304E02
  1. Apply battery voltage to the mirror terminals and check the operation of the mirror heater.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Mirror becomes warm

    If the result is not as specified, replace the mirror assembly.



2. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH


B070998E03
  1. Disconnect the mirror connector.

  1. Apply battery voltage and check the operation of the mirror.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 5 (MV)
    Battery negative (-) → Terminal 4 (M+)
    Turns upward (A)
    Battery positive (+) → Terminal 4 (M+)
    Battery negative (-) → Terminal 5 (MV)
    Turns downward (B)
    Battery positive (+) → Terminal 3 (MH)
    Battery negative (-) → Terminal 4 (M+)
    Turns left (C)
    Battery positive (+) → Terminal 4 (M+)
    Battery negative (-) → Terminal 3 (MH)
    Turns right (D)

    If the result is not as specified, replace the mirror assembly.



    B076303E02
  1. Apply battery voltage to the mirror terminals and check the operation of the mirror heater.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 1
    Mirror becomes warm

    If the result is not as specified, replace the mirror assembly.