DTC No.
| DTC Detection Condition
| Trouble Area
|
01-D5*1, *3
| When either condition below is met: - Component shown by sub-code is (was) disconnected from system when turning power switch on (ACC or IG).
- Communication condition with device that code shows cannot be obtained when hybrid system starts.
| - Power source circuit of component shown by sub-code
- AVC-LAN circuit between multi-display and component shown by sub-code
- Component shown by sub-code
|
01-D8*2, *3
| Component shown by sub-code is (was) disconnected from system after hybrid system start.
|
01-D9*1, *3
| Device that had functioned before the hybrid system stopped is (was) disconnected from system when power switch is (was) ON (IG or ACC).
|
01-DA*3
| When either condition below is met: - No response is identified when changing mode.
- Sound and image do not change by switch operation.
|
01-DB*1, *3
| Dual alarm is detected.
|
01-DE*3
| Slave device has been disconnected after hybrid system start.
|