Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    58-43    SPD Signal Error

DTC    80-43    SPD Signal Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
58-43
Difference between GPS speed and SPD pulse is detected.
  1. Speed signal circuit
  1. Navigation ECU
80-43
Difference between GPS speed and SPD pulse is detected.

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.

1.CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)


    E120089
  1. Enter the "Navigation Check" mode (Vehicle Sensors) (Click here).

  1. While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.

    OK:
    The readings are almost equal.



OK
REPLACE NAVIGATION ECU
NG


2.PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE
  1. Refer to "Speed signal does not change in the navigation check mode" in the problem symptoms table.


NEXT

END