Home › HYBRID SYSTEM › P112 HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0630-804    VIN not Programmed or Mismatch-ECM / PCM

for Preparation Click here


DESCRIPTION

DTC P0630 is set if the Vehicle Identification Number (VIN) is not stored in the HV control ECU or the input VIN is not accurate. Input the VIN with the Techstream (Click here).

DTC No.
INF No.
DTC Detection Condition
Trouble Area
P0630
804
  1. VIN not stored in HV control ECU
  2. Input VIN in HV control ECU not accurate
HV control ECU

INSPECTION PROCEDURE

1.READ CURRENT DTC

NOTICE:
If P0630 is set, the VIN must be input to the HV control ECU using the Techstream. However, all DTCs are cleared automatically by the tester when inputting the VIN. If DTCs other than P0630-804 are set, check them first.


NEXT


2.INPUT VIN WITH THE TECHSTREAM
  1. Input the VIN with the Techstream (Click here).

    NOTICE:
    Be sure to check the auxiliary battery voltage before performing VIN writing because VIN writing cannot be performed if the auxiliary battery voltage is below 10 V.


NEXT


3.READ OUTPUT DTC
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch ON (IG).

  1. Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

  1. Check if DTCs are output (Click here).

    OK:
    DTC P0630-804 is not output.



NG
REPLACE HYBRID VEHICLE CONTROL ECU
OK

END