Home › RESTRAINTS › SEAT BELT › REAR SEAT INNER BELT ASSEMBLY

REAR SEAT INNER BELT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH
  1. Install the anchor bracket with the 2 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



2. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY RH
  1. Install the anchor bracket with the 2 bolts.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }



3. INSTALL REAR SEAT INNER BELT ASSEMBLY CENTER


B074540E01
  1. Install the rear seat inner belt with the bolt, as shown in the illustration.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Make sure that the anchor part does not run onto the protruding part of the floor panel.



4. INSTALL REAR SEAT INNER BELT ASSEMBLY RH


B074539E01
  1. Install the rear seat inner belt with the bolt, as shown in the illustration.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Make sure that the anchor part does not run onto the protruding part of the floor panel.



5. CONNECT REAR SEAT BELT ASSEMBLY OUTER CENTER (for Floor Anchor)


B076014E03
  1. Install the floor anchor part of the rear seat inner belt with the bolt, as shown in the illustration.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Make sure that the anchor part does not run onto the protruding part.



6. INSTALL REAR SEAT CUSHION ASSEMBLY

NOTICE:
When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.



    B132601E01
  1. Attach the seat cushion's rear hook to the center hinge.

  1. Insert the inner belts through the slits on the seat cushion.



    B132602
  1. Attach the seat cushion's 2 front hooks to the vehicle body.

  1. Confirm that the seat cushion is firmly installed.