BACK WINDOW FIX GLASS > REMOVAL |
| 1. REMOVE BACK DOOR LOWER TRIM BOARD ASSEMBLY |
Using a screwdriver, detach the 11 clips and remove the lower trim board.
| 2. REMOVE BACK DOOR UPPER TRIM BOARD ASSEMBLY |
![]() |
Using a screwdriver, detach the 5 clips and remove the upper trim board.
| 3. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY |
Disconnect the back door opener switch connector.
Remove the 4 nuts.

Using a screwdriver, detach the 2 clips and remove the garnish (with back door opener switch).
![]() |
Remove the 2 screws and back door opener switch from the garnish.
| 4. REMOVE REAR SPOILER SUB-ASSEMBLY |
![]() |
Put protective tape under the rear spoiler.
Remove the 4 bolts.
Regular Type:
![]() |
Using a screwdriver, detach the 3 clips.
Large Type:
![]() |
Using a screwdriver, detach the 3 clips and peel off the double-sided tape.
Disconnect the center stop light connector and remove the rear spoiler.
| 5. REMOVE BACK DOOR GLASS |
![]() |
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
![]() |
From the interior, insert a piano wire between the vehicle body and back door glass as shown in the illustration.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Cut through the adhesive by pulling the piano wire around the back door glass.
Using suction cups, remove the back door glass.
| 6. CLEAN BACK DOOR GLASS |
![]() |
Clean the outer edge of the back door glass with white gasoline.
| 7. CLEAN VEHICLE BODY |
![]() |
Using a scraper, remove the moulding and adhesive from the back door glass.
Clean and shape the contact surface of the vehicle body.
On the contact surface of the vehicle body, use a knife to cut away excess adhesive as shown in the illustration.
Clean the contact surface of the vehicle body with cleaner.