Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each unit of the audio system connected to the AVC-LAN (communication bus) transfers the signal of each switch by communication.
When a short to +B or short to ground occurs in this AVC-LAN, the audio system will not function normally as the communication is discontinued.

INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER


    E107228E01
  1. for 9 Speaker System:
    Disconnect the R5 and R6 receiver connectors.

  1. for 6 Speaker System:
    Disconnect the R5 receiver connector.

  1. Measure the resistance of the receiver.

    Standard resistance:
    Tester Connection
    Specified Condition
    R5-9 (TX1+) - R5-10 (TX1-)*1
    60 to 80 Ω
    R5-9 (TX+) - R5-10 (TX-)*2
    60 to 80 Ω
    R6-5 (TX+) - R6-15 (TX-)*2
    60 to 80 Ω

    HINT:
    1. *1: for 6 speaker system
    2. *2: for 9 speaker system



NG
REPLACE RADIO RECEIVER
OK


2.CHECK WIRE HARNESS

HINT:
For details of the connectors, refer to the "TERMINALS OF ECU" (Click here).



  1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.

    1. Disconnect all connectors in all AVC-LAN circuits.



    2. Check for an open or short in all AVC-LAN circuits.

      OK:
      There is no open or short circuit.


      E126611E01



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE