Home › BODY ELECTRICAL › HORN › LOW PITCHED HORN

LOW PITCHED HORN > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER COVER


B130316E01
  1. Put protective tape under the front fender.

  1. Using a clip remover, remove the 3 clips.

  1. Remove the 2 radiator grille protectors and 4 screws.

  1. Detach the 8 claws.



    B078079E02
  1. Detach the 4 claws and remove the bumper cover.

    1. Hold the front bumper cover on its upper and lower parts with your hands as shown in the illustration.

    2. Pull up the front bumper cover's lower part while holding its upper part securely.

      NOTICE:
      1. The claw will not disengage unless the front bumper cover's upper part is securely held.
      2. Do not forcibly pull up the front bumper. This will deform the claw.

  1. w/ Fog light:
    Disconnect the 2 fog light connectors.



2. REMOVE LOW PITCHED HORN


B127786E01
  1. Disconnect the horn connector.

  1. Remove the bolt and horn.