Home › ENGINE › 1NZ-FXE EXHAUST › EXHAUST PIPE

EXHAUST PIPE > INSTALLATION

for Preparation Click here



1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    A111834
  1. Using a vernier caliper, measure the free length of the compression spring.

    Minimum length:
    40.5 mm (1.594 in.)

    If the length is less than the minimum, replace the compression spring.



    A076194E04
  1. Using a plastic-faced hammer and wooden block, tap in a new gasket until its surface is flush with the exhaust manifold.

    NOTICE:
    1. Tap in the gasket in the correct direction.
    2. Do not reuse the removed gasket.
    3. Do not push in the gasket while installing the exhaust pipe.

  1. Connect the 2 exhaust pipe supports, and install the exhaust pipe.

  1. Install the 2 compression springs and 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



2. INSTALL TAILPIPE ASSEMBLY


    A111834
  1. Using a vernier caliper, measure the free length of the compression spring.

    Minimum length:
    38.5 mm (1.516 in.)

    If the length is less than the minimum, replace the compression spring.



    A078440E01
  1. Install a new gasket to the front exhaust pipe.

    NOTICE:
    Do not reuse the gasket.

  1. Connect the 2 exhaust pipe supports, and install the tail pipe.

  1. Install the 2 compression springs and 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



3. INSTALL FRONT FLOOR PANEL BRACE


    A086201
  1. Install the floor panel brace with the 2 bolts.

    Torque:
    30 N*m{ 302 kgf*cm , 22 ft.*lbf }



4. INSTALL HEATED OXYGEN SENSOR


A087474E01
  1. Using SST, install the sensor.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 in.*lbf } for use with SST
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use without SST

    HINT:
    Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).

  1. Install the wire harness clamp bracket to the sensor.

  1. Install the grommet of the sensor to the vehicle.

  1. Connect the sensor connector.

  1. Install the floor carpet front with the clip.



5. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER


B074061E03
  1. Attach the 4 claws and 2 clips to install the instrument panel finish panel.

  1. Install the clip.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. CHECK FOR EXHAUST GAS LEAKS
If gas is leaking, tighten the problem areas to stop the leak. Replace damaged parts as necessary.


8. INSTALL REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Install the floor board, and then attach the 4 claws.



9. INSTALL REAR DECK FLOOR BOX


    A088354E01
  1. Install the rear deck floor box to the vehicle.



10. INSTALL REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Install the floor board, and then lock the 2 cover knobs.



11. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting the cable from the negative (-) battery terminal.