Home › ENGINE › 1NZ-FXE EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Unlock the 2 washer tank cover knobs, and then remove the rear floor board.



2. REMOVE REAR DECK FLOOR BOX


    A088354E01
  1. Remove the rear deck floor box from the vehicle.



3. REMOVE REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Detach the 4 claws, and then remove the floor board.



4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



5. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER


B074061E02
  1. Using a clip remover, remove the clip from the instrument panel finish panel lower center.

  1. Detach the 4 claws and 2 clips, and remove the instrument panel finish panel.



6. REMOVE HEATED OXYGEN SENSOR


A087436E01
  1. Using a clip remover, remove the clip.

  1. Fold back the floor carpet front.



    A087437E01
  1. Disconnect the sensor connector.

  1. Remove the grommet of the sensor from the vehicle.



    A087474E01
  1. Remove the wire harness clamp bracket from the sensor.

  1. Using SST, remove the sensor.

    SST
    09224-00010  



7. REMOVE FRONT FLOOR PANEL BRACE


    A086201
  1. Remove the 2 bolts and floor panel brace.



8. REMOVE TAILPIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Remove the tailpipe from the 2 exhaust supports.



  1. Remove the gasket from the front exhaust pipe.


    A086202E01



9. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs.

  1. Remove the front exhaust pipe from the 2 exhaust pipe supports.



  1. Remove the gasket from the exhaust manifold.


    A086203