Home › ENGINE › 1NZ-FXE ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE NO. 1 TAPER SCREW PLUG


    A088717E02
  1. Using a 10 mm hexagon wrench, remove the taper screw plug and gasket.



2. REMOVE OIL CONTROL VALVE FILTER


    A038128E02
  1. Using an 8 mm hexagon wrench, remove the screw plug.

  1. Remove the filter and gasket.



3. REMOVE VALVE LIFTER


A088718E01

HINT:
Keep the valve lifters in the correct order so that they can be returned to their original locations when reassembling.



4. REMOVE INTAKE VALVE


    A037109E02
  1. Using SST, compress the valve spring and remove the 2 retainer locks, valve, retainer and valve spring.

    SST
    09202-70020   (09202-00010, 09202-01010, 09202-01020)

    HINT:
    Keep the valves, valve springs and spring retainers in the correct order so that they can be returned to their original locations when reassembling.



5. REMOVE EXHAUST VALVE
  1. Using SST, compress the valve spring and remove the 2 retainer locks, valve, retainer and valve spring.

    SST
    09202-70020   (09202-00010, 09202-01010, 09202-01020)

    HINT:
    Keep the valves, valve springs and spring retainers in the correct order so that they can be returned to their original locations when reassembling.



6. REMOVE VALVE STEM OIL SEAL


    A080961E01
  1. Using needle-nose pliers, remove the oil seal.



7. REMOVE VALVE SPRING SEAT


    A080962E01
  1. Using compressed air and a magnetic finger, remove the valve spring seat.

    HINT:
    Keep the valve seats in the correct order so that they can be returned to their original locations when reassembling.



8. REMOVE STUD BOLT


  1. Using E5 and E7 "torx" sockets, remove the 7 stud bolts.


    A092363E02



9. REMOVE CAMSHAFT BEARING CAP SETTING RING PIN


    A088720E01
  1. Remove the 2 ring pins indicated in the illustration.