Home › ENGINE › 1NZ-FXE ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > REASSEMBLY

for Preparation Click here



1. INSTALL CAMSHAFT BEARING CAP SETTING RING PIN


    A080980E03
  1. Using a plastic-faced hammer, tap in a new ring pin to the specified protrusion height.

    Standard protrusion height:
    8.5 to 9.5 mm (0.335 to 0.374 in.)



2. INSTALL STUD BOLT


  1. Using E5 and E7 "torx" sockets, install the 7 stud bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7.4 ft.*lbf } for bolt A
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf } for bolt B
    10 N*m{ 102 kgf*cm , 7.4 ft.*lbf } for bolt C
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf } for bolt D



    A117402E01



3. INSTALL VALVE STEM OIL SEAL


    A092940E02
  1. Apply a light coat of engine oil to the valve stem.

    NOTICE:
    Installing the oil seals for the intake and exhaust onto the opposite valve guide bush may cause failures.

    HINT:
    The intake valve oil seal is gray and the exhaust valve oil seal is black.



    A001063E01
  1. Using SST, push in a new oil seal.

    SST
    09201-41020  



4. INSTALL INTAKE VALVE


    A001065E01
  1. Install the valve, spring seat, valve spring and spring retainer.

    NOTICE:
    Install the same parts in the same combination to their original locations.



    A037109E01
  1. Using SST, compress the valve spring and place the 2 retainer locks around the valve stem.

    SST
    09202-70020   (09202-00010)



    A007307E01
  1. Using a plastic-faced hammer and valve stem (not in use) with the tip wrapped in tape, lightly tap the valve stem tip to ensure a proper fit.

    NOTICE:
    Be careful not to damage the valve stem tip.



5. INSTALL EXHAUST VALVE
  1. Install the valve, spring seat, valve spring, and spring retainer.

  1. Using SST, compress the valve spring and place the 2 retainer locks around the valve stem.

    SST
    09202-70020   (09202-00010)

  1. Using a plastic-faced hammer and valve stem (not in use) with the tip wrapped in tape, lightly tap the valve stem tip to ensure a proper fit.

    NOTICE:
    Be careful not to damage the valve stem tip.



6. INSTALL OIL CONTROL VALVE FILTER


    A050664E01
  1. Using an 8 mm hexagon wrench, install the filter with a new gasket and the screw plug.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }



7. INSTALL VALVE LIFTER
  1. Apply a light coat of engine oil to the valve lifter.

  1. Install the valve lifter.

  1. Check that the valve lifter rotates smoothly by hand.



8. INSTALL NO. 1 TAPER SCREW PLUG


    A088717E02
  1. Using a 10 mm hexagon wrench, install the taper screw plug with a new gasket.

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf }