Home › ENGINE › 1NZ-FXE COOLING › COOLING FAN RELAY

COOLING FAN RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT INTEGRATION RELAY (UNIT C: NO. 1 FAN (FAN NO. 1) RELAY)


  1. Inspect the resistance of the fan relay.



    1. Measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3G-1- 3G-4
      10 kΩ or higher
      3G-1- 3G-4
      Below 1 Ω
      (apply battery voltage to terminals 3G-2 and 3G-3)



      A129013E01

      1. If the resistance is not as specified, replace the integration relay.



2. INSPECT NO. 2 FAN RELAY (Marking: FAN NO. 2)


A087121E01
  1. Remove the relay from the engine room relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 4
    Below 1 Ω
    3 - 5
    10 kΩ or higher
    3 - 4
    10 kΩ or higher
    (when battery voltage is applied to terminals 1 and 2)
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.

  1. Install the relay.



3. INSPECT NO. 3 FAN RELAY (Marking: FAN NO. 3)


B060778E46
  1. Remove the relay from the engine room relay block.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.

  1. Install the relay.