Home › ENGINE › 1NZ-FXE ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL DRIVE BELT
  1. Temporarily install the belt on each pulley.



2. ADJUST DRIVE BELT TENSION


    A086912E01
  1. Turn adjust bolt B to adjust the belt tension.

  1. Tighten nut A.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }



3. CHECK DRIVE BELT TENSION


    A087786E01
  1. Using a belt tension gauge, measure the belt tension.
    Belt tension gauge:
    DENSO BTG-20 (95506-00020)
    Borroughs No. BT-33-73F

    Standard drive belt tension:
    Item
    Specified Condition
    New belt
    99 to 121 lbf
    Used belt
    55 to 77lbf


    HINT:
    A122295E01
    1. After installing the drive belt, check that it fits properly in the ribbed grooves. Check with your hands to confirm that the belt has not slipped out of the groove on the bottom of the crankshaft pulley.
    2. A "new belt" is a belt which has been used less than 5 minutes on a running engine.
    3. A "used belt" is a belt which has been used on a running engine for 5 minutes or more.
    4. After installing a new belt, run the engine for approximately 5 minutes and then recheck the tension.



  1. Reference:
    Check the drive belt deflection.



      A093818E02
    1. When not using a belt tension gauge, measure the belt deflection.
      Pressing force: 98 N (10 kgf, 22 lbf)

      Standard belt deflection:
      Item
      Specified Condition
      New belt
      9.0 to 12.0 mm (0.35 to 0.47 in.)
      Used belt
      11 to 15 mm (0.43 to 0.59 in.)

      NOTICE:
      1. Check the drive belt deflection at the specified point.
      2. When installing a new belt, set its tension value as specified.
      3. When inspecting a belt which has been used over 5 minutes, apply the specification for "Used belt".
      4. When reinstalling a belt which has been used over 5 minutes, adjust its deflection and tension to the intermediate value of each specification for "Used belt".
      5. Belt tension and deflection should be checked after 2 revolutions of engine cranking.
      6. When using a belt tension gauge, confirm the accuracy by using a master gauge first.



4. CONNECT NO. 1 AIR CLEANER INLET


    A086911E01
  1. Connect the air cleaner inlet to the air cleaner case and tighten the clamp.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



5. INSTALL ENGINE UNDER COVER RH