Home › ENGINE › 1NZ-FXE ENGINE MECHANICAL › ENGINE UNIT

ENGINE UNIT > REPLACEMENT

for Preparation Click here



1. REPLACE OIL PUMP SEAL

HINT:
There are 2 ways to replace the oil seal: remove it with the timing chain cover removed, or remove it with the timing chain cover installed.



    A035281E06
  1. If the timing chain cover is removed:

    1. Using a screwdriver, remove the oil seal.

      HINT:
      Tape the screwdriver tip before use.



    2. A037153E02
    3. Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing chain cover edge.

      SST
      09950-60010   (09951-00250, 09951-00380, 09952-06010)
      09950-70010   (09951-07100)

      NOTICE:
      1. Be careful not to tap the oil seal at an angle.
      2. Keep the lip free of foreign objects.

    4. Apply multi-purpose grease to the lip of the oil seal.



    A050694E02
  1. If the timing chain cover is installed:

    1. Using a knife, cut off the lip of the oil seal.

    2. Using a screwdriver with the tip wrapped in tape, pry out the oil seal.

      NOTICE:
      After removal, check if the crankshaft is not damaged. If it is damaged, smooth the surface with 400-grit sandpaper.

    3. Apply multi-purpose grease to the lip of a new oil seal.

      NOTICE:
      Keep the lip free of foreign objects.



    4. A066485E01
    5. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

      SST
      09223-22010  

      NOTICE:
      1. Be careful not to tap the oil seal at an angle.
      2. Wipe any extra grease off the crankshaft.



2. REPLACE ENGINE REAR OIL SEAL


    A088160E02
  1. Using a knife, cut off the lip of the oil seal.

  1. Using a screwdriver with the tip wrapped in tape, pry out the oil seal.

    NOTICE:
    After removal, check if the crankshaft is damaged. If it is damaged, smooth the surface with 400-grit sandpaper.



    A088161E01
  1. Apply multi-purpose grease to the lip of a new oil seal.

    NOTICE:
    Keep the lip free of foreign materials.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-56010  

    NOTICE:
    1. Be careful not to tap the oil seal at an angle.
    2. Wipe any extra grease off the crankshaft.