Home › ENGINE › 1NZ-FXE COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


    A088174E01
  1. Remove the 6 clips and radiator support opening cover.



2. REMOVE ENGINE UNDER COVER LH


3. REMOVE ENGINE UNDER COVER RH


4. DRAIN ENGINE COOLANT (for Engine)
  1. Disconnect the coolant heat storage water pump connector.

  1. Connect a vinyl hose to the drain cock of the radiator.

  1. Connect a vinyl hose to the drain cock of the engine.

  1. Connect a vinyl hose to the drain cock of the coolant heat storage tank.

    CAUTION:
    If the tank has any malfunctions, the tank surface becomes hot. To prevent injuries from burns, do not touch the tank.

  1. Loosen the drain cock plugs of the radiator, engine and coolant heat storage tank, then drain the coolant.

    CAUTION:
    Even if the engine is cold, the coolant in the coolant heat storage tank is still hot. Be careful of the hot coolant when draining it.

    HINT:
    Record the amount of the drained coolant. It will be referred to when refilling the tank with coolant.



  1. Remove the radiator cap.


    A124655E01

  1. Drain the coolant in the radiator reservoir.



5. REMOVE GENERATOR V BELT


    A086912E01
  1. Loosen nut A.

  1. Turn adjust bolt B, and then release the belt tension.

  1. Remove the belt.



6. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH


    A087348E01
  1. Put a wooden block on a jack. Support the oil pan with the jack.



    A087349E01
  1. Remove the 3 bolts and 4 nuts, then remove the engine mounting insulator RH.



7. REMOVE WATER PUMP PULLEY


A092654E01
  1. Using SST, hold the pump pulley.

    SST
    09960-10010   (09962-01000, 09963-00600)

  1. Remove the 3 bolts and pump pulley.



8. REMOVE WATER PUMP ASSEMBLY


B009338E01
  1. Remove the 3 bolts and 2 nuts.

  1. Remove the water pump and gasket.