SFI SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC (Using Techstream) |
Connect Techstream to the DLC3.
Turn the power switch ON (IG) and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Code.
Check for DTCs and freeze frame data, and then write them down.
Check the details of the DTC(s) (Click here).
| CLEAR DTC (Using Techstream) |
Connect Techstream to the DLC3.
Turn the power switch ON (IG) and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Code.
Press the YES button.
| CLEAR DTC (Without Using Techstream) |
![]() |
Remove the EFI and ETCS fuses from the engine room relay block for more than 60 seconds, or disconnect the battery cable for more than 60 seconds.