Home › ENGINE › 1NZ-FXE COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR SUPPORT OPENING COVER


    A088174E01
  1. Remove the 6 clips and radiator support opening cover.



2. REMOVE ENGINE UNDER COVER LH


3. REMOVE ENGINE UNDER COVER RH


4. DRAIN ENGINE COOLANT (for Engine)
  1. Disconnect the coolant heat storage water pump connector.

  1. Connect a vinyl hose to the drain cock of the radiator.

  1. Connect a vinyl hose to the drain cock of the engine.

  1. Connect a vinyl hose to the drain cock of the coolant heat storage tank.

    CAUTION:
    If the tank has any malfunctions, the tank surface becomes hot. To prevent injuries from burns, do not touch the tank.

  1. Loosen the drain cock plugs of the radiator, engine and coolant heat storage tank, then drain the coolant.

    CAUTION:
    Even if the engine is cold, the coolant in the coolant heat storage tank is still hot. Be careful of the hot coolant when draining it.

    HINT:
    Record the amount of the drained coolant. It will be referred to when refilling the tank with coolant.



  1. Remove the radiator cap.


    A124655E01

  1. Drain the coolant in the radiator reservoir.



5. REMOVE WATER INLET


    A086915E01
  1. Remove the 2 nuts and disconnect the water inlet from the cylinder block.



6. REMOVE THERMOSTAT


    A088872E01
  1. Remove the thermostat.

  1. Remove the gasket from the thermostat.