Home › ENGINE › 1NZ-FXE IGNITION › IGNITION COIL

IGNITION COIL > INSTALLATION

for Preparation Click here



1. INSTALL IGNITION COIL ASSEMBLY


    A126797
  1. Install the 4 ignition coils with the 4 bolts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

  1. Connect the 4 ignition coil connectors.



2. INSTALL ENGINE ROOM NO. 2 RELAY BLOCK


    A087417E01
  1. Install the relay block with the 2 bolts.

    Torque:
    8.4 N*m{ 86 kgf*cm , 74 ft.*lbf }



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. INSTALL REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Install the floor board, and then attach the 4 claws.



5. INSTALL REAR DECK FLOOR BOX


    A088354E01
  1. Install the rear deck floor box to the vehicle.



6. INSTALL REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Install the floor board, and then lock the 2 cover knobs.



7. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.