Home › ENGINE › 1NZ-FXE IGNITION › IGNITION COIL

IGNITION COIL > REMOVAL

for Preparation Click here



1. REMOVE REAR NO. 2 FLOOR BOARD


    A088353E01
  1. Unlock the 2 washer tank cover knobs, and then remove the rear floor board.



2. REMOVE REAR DECK FLOOR BOX


    A088354E01
  1. Remove the rear deck floor box from the vehicle.



3. REMOVE REAR NO. 3 FLOOR BOARD


    A088355E02
  1. Detach the 4 claws, and then remove the floor board.



4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



5. DISCONNECT ENGINE ROOM NO. 2 RELAY BLOCK


    A087417E01
  1. Remove the 2 bolts and disconnect the relay block.



6. REMOVE IGNITION COIL ASSEMBLY
  1. Disconnect the 4 ignition coil connectors.



    A126797
  1. Remove the 4 bolts and pull out the 4 ignition coils.