Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
  1. Measure the resistance of the oil control valve.

    Standard resistance:
    6.9 to 7.9 Ω at 20°C (68°F)

    If the result is not as specified, replace the camshaft timing oil control valve assembly.



    A050377E02
  1. Inspect the operation.

    1. Connect the battery positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and inspect the movement of the valve.

      Specified condition:
      Condition
      Specified Condition
      Battery positive (+) voltage is applied
      Valve moves in black arrow direction shown in illustration
      Battery positive (+) voltage is cut off
      Valve moves in white arrow direction shown in illustration

      If the result is not as specified, replace the camshaft timing oil control valve assembly.

      NOTICE:
      Confirm that the valve moves freely and is not stuck in any position.

      HINT:
      Foreign objects in the oil can cause subtle pressure leaks in the valve. The pressure leaks will cause the cam to advance. This condition will usually set a DTC.