Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR


  1. Measure the resistance of the sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    2.32 to 2.59 kΩ
    1 - 2
    80°C (176°F)
    0.310 to 0.326 kΩ

    NOTICE:
    If checking the sensor in water, be careful not to allow water to contact the terminals. After checking, dry the sensor.



    A114177E01

    If the result is not as specified, replace the engine coolant temperature sensor.