Home
›
ENGINE
›
1NZ-FXE ENGINE CONTROL SYSTEM
›
CRANKSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR > INSPECTION
for Preparation
Click here
1. INSPECT CRANKSHAFT POSITION SENSOR
Measure the resistance of the sensor.
Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Cold
985 to 1,600 Ω
1 - 2
Hot
1,265 to 1,890 Ω
NOTICE:
The terms "Cold" and "Hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).
If the result is not as specified, replace the crankshaft position sensor.