AIRBAG SYSTEM > Source Voltage Drop |

| 1.CHECK WIRE HARNESS (CENTER AIRBAG SENSOR - BATTERY) |
![]() |
Turn the power switch OFF.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Disconnect the connectors from the center airbag sensor.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| A18-21 (IG2) - Body ground | Power switch ON (IG) | 11 to 14 V |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (CENTER AIRBAG SENSOR - BODY GROUND) |
![]() |
Measure the resistance of the wire harness side connector.
| Tester Connection | Specified Condition |
| A18-25 (E1) - Body ground | Below 1 Ω |
| A18-26 (E2) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK SRS WARNING LIGHT |
Turn the power switch OFF.
Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
Connect the center airbag sensor connector.
Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
Turn the power switch ON (IG), and wait for at least 6 seconds.
Operate all components of the electrical system (defogger, wiper, headlight, heater, blower, etc.) and check that the SRS warning light does not come on.
|
| ||||
| OK | ||
| ||