Home › RESTRAINTS › SEAT BELT › REAR SEAT OUTER BELT ASSEMBLY

REAR SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the RH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR SEAT CUSHION ASSEMBLY


    B132600E01
  1. Detach the seat cushion's 2 front hooks from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame deforms easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat for the other hook.

  1. Detach the seat cushion's rear hook.

  1. Remove the seat cushion.



3. REMOVE REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.



4. REMOVE REAR SIDE SEAT BACK FRAME RH
  1. Remove the bolt and side seatback.



5. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH


6. REMOVE REAR SEAT BACK ASSEMBLY RH
  1. Remove the bolt and disconnect the rear seat outer belt floor anchor.

  1. Open the front part of the rear No. 1 floor deck board.

  1. Tilt the seatback down toward the front of the vehicle.



    B076029E01
  1. Remove the 2 bolts and seatback.



7. REMOVE TONNEAU COVER ASSEMBLY


8. REMOVE REAR FLOOR NO. 2 BOARD


9. REMOVE REAR FLOOR NO. 1 BOARD


10. REMOVE REAR FLOOR NO. 4 BOARD


11. REMOVE DECK FLOOR BOX LH


12. REMOVE REAR DECK FLOOR BOX


13. REMOVE REAR DECK TRIM COVER


    B076395E02
  1. Using a screwdriver, detach the 4 claws and remove the trim cover.

    HINT:
    Tape the screwdriver tip before use.



14. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH


    B079224E02
  1. Remove the screw and 2 bolts.

  1. Using a clip remover, remove the clip.

  1. Using a screwdriver, detach the 6 claws and 2 clips, and remove the side panel.

    HINT:
    Tape the screwdriver tip before use.



15. REMOVE ROOF SIDE GARNISH INNER RH

HINT:
Use the same procedures described for the LH side.



16. REMOVE REAR SEAT OUTER BELT ASSEMBLY RH
  1. Remove the 2 bolts and outer belt.

  1. Remove the 2 bolts and belt outer anchor bracket RH.



17. REMOVE REAR SEAT OUTER BELT ASSEMBLY CENTER

HINT:
RH side only.

  1. Remove the bolt and disconnect the floor anchor.



    B057844E03
  1. Using a screwdriver, detach the 4 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the rear seat headrest RH .

  1. Remove the rear seat center headrest .

  1. Remove the rear seat back cover RH .

  1. Remove the bolt on the retractor side and belt.