Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL FRONT BUMPER SIDE SUPPORT LH
  1. Install the side support with 2 screws.



2. INSTALL FRONT BUMPER SIDE SUPPORT RH
  1. Install the side support with 2 screws.



3. INSTALL FRONT BUMPER REINFORCEMENT
  1. Install the reinforcement with the 4 nuts.

    Torque:
    67 N*m{ 683 kgf*cm , 49 ft.*lbf }

  1. Install the 4 wire harness clamps.



4. INSTALL FRONT BUMPER ENERGY ABSORBER


5. INSTALL FRONT BUMPER COVER


    B132997E01
  1. Put protective tape under the front fender.

  1. w/ Fog light:
    Connect the 2 fog light connectors.

  1. Attach the 12 claws to install the bumper cover.

  1. Install the 4 screws and 3 clips.

  1. Install the 2 radiator grille protectors.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



6. INSTALL FRONT SPOILER COVER


    B130317
  1. Install the spoiler cover with the 7 screws.



7. INSTALL CENTER NO. 4 ENGINE UNDER COVER


    B130318
  1. Install the under cover with the 5 screws and 4 bolts.



8. INSTALL FRONT FENDER LINER LH


    B130315
  1. Install the fender liner with the clip.



9. INSTALL FRONT FENDER LINER RH

HINT:
Use the same procedure described for the LH side.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


11. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.