REAR BUMPER > REMOVAL |
| Item | Specified Condition |
| Spoiler | 40 to 60°C (104 to 140°F) |
| Bumper cover | 20 to 30°C (68 to 86°F) |
| 1. REMOVE REAR BUMPER COVER |
![]() |
Put protective tape under the quarter panel.
Remove the 5 screws, nut and 2 stoppers.
Using a clip remover, remove the 4 clips.
Using a screwdriver, detach the 10 claws.
![]() |
Detach the 2 claws and remove the bumper cover.
Hold the rear bumper cover on its upper and lower parts with your hands as shown in the illustration.
Pull up the rear bumper cover's lower part while holding its upper part securely.
| 2. REMOVE REAR SIDE SPOILER LH |
![]() |
Using a screwdriver, remove the 2 retainers.
Remove the 2 clips and 3 screws.
![]() |
Put protective tape under the rear bumper cover.
Using a heat light, heat the spoiler.
Cut the double-sided tape that holds the spoiler to the bumper cover with a knife.
Remove the spoiler.
| 3. REMOVE REAR SIDE SPOILER RH |
| 4. REMOVE REAR NO. 1 SPOILER |
![]() |
Using a clip remover, remove the 5 clips.
![]() |
Put protective tape under the rear bumper cover.
Using a heat light, heat the spoiler.
Cut the double-sided tape that holds the spoiler to the bumper cover with a knife.
Remove the spoiler.
| 5. REMOVE REAR BUMPER ENERGY ABSORBER |
| 6. REMOVE REAR BUMPER CENTER BRACKET |
| 7. REMOVE REAR BUMPER REINFORCEMENT SUB-ASSEMBLY |
Remove the 4 nuts and reinforcement.
| 8. REMOVE REAR BUMPER ARM SUB-ASSEMBLY LH |
Remove the 2 bolts and bumper arm.
| 9. REMOVE REAR BUMPER ARM SUB-ASSEMBLY RH |
Remove the 2 bolts and bumper arm.
| 10. REMOVE REAR BUMPER SIDE RETAINER LH |
Remove the 2 screws and side retainer.
| 11. REMOVE REAR BUMPER SIDE RETAINER RH |
Remove the 2 screws and side retainer.