Home › BODY › EXTERIOR › REAR SPOILER

REAR SPOILER > INSTALLATION

for Preparation Click here



1. INSTALL CENTER STOP LIGHT ASSEMBLY


E071102E01
  1. Install the center stop light with 2 screws.

  1. Connect the connector.



2. INSTALL REAR SPOILER SUB-ASSEMBLY


  1. Large Type:

    HINT:
    When installing the spoiler, heat the vehicle body and spoiler using a heat light.

    Heating temperature:
    Item
    Temperature
    Vehicle Body
    40 to 60°C (104 to 140°F)
    Spoiler
    20 to 30°C (68 to 86°F)

    NOTICE:
    Do not heat the vehicle body and rear spoiler excessively.


    1. Put protective tape under the rear spoiler.

    2. Using a heat light, heat the vehicle body surface and rear spoiler.

    3. Remove the double-sided tape from the vehicle body and rear spoiler.

    4. Wipe off any tape adhesive residue with cleaner.



    5. Apply new double-sided tape to the rear spoiler.


      B157869E01

    6. Using a heat light, heat the vehicle body and rear spoiler.

    7. Remove the release paper from the rear spoiler.

      HINT:
      After removing the release paper, keep the exposed adhesive free from foreign matter.

  1. Connect the center stop light connector.



    B157868E01
  1. Attach the 3 clips to install the rear spoiler.



    B157864
  1. Install the 4 bolts.



3. INSTALL REAR WIPER MOTOR ASSEMBLY


I038386E01
  1. Install the rear wiper motor with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.



4. INSTALL BACK DOOR UPPER TRIM BOARD ASSEMBLY


B077067E03
  1. Attach the 5 clips to install the upper trim board.



5. INSTALL BACK DOOR LOWER TRIM BOARD ASSEMBLY


B075175E04
  1. Attach the 11 clips to install the lower trim board.



6. INSTALL REAR WIPER ARM ASSEMBLY


I040979E01
  1. Stop the wiper motor at the automatic stop position.

  1. Clean the wiper arm serration with a round file or equivalent.

  1. Clean the wiper pivot serration with a wire brush.



    I039800E02
  1. Install the arm and blade with the nut. Make sure that the arm and blade comes to the position shown in the illustration.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    HINT:
    1. Hold down the arm hinge by hand while installing the nut.
    2. Install the arm and blade so that the rear wiper blade is aligned with the defogger line.

  1. Install the cap.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


8. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.