Home › BODY › EXTERIOR › REAR SPOILER

REAR SPOILER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR WIPER ARM ASSEMBLY
  1. Remove the nut and rear wiper arm.



3. REMOVE BACK DOOR LOWER TRIM BOARD ASSEMBLY
  1. Using a screwdriver, detach the 11 clips and remove the lower trim board.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE BACK DOOR UPPER TRIM BOARD ASSEMBLY


    B077067E03
  1. Using a screwdriver, detach the 5 clips and remove the upper trim board.

    HINT:
    Tape the screwdriver tip before use.



5. REMOVE REAR WIPER MOTOR ASSEMBLY


    I038386E01
  1. Disconnect the connector.

  1. Remove the 3 bolts and rear wiper motor.



6. REMOVE REAR SPOILER SUB-ASSEMBLY


    B157864E01
  1. Put protective tape under the rear spoiler.

  1. Remove the 4 bolts.



  1. Regular Type:



      B157880
    1. Using a screwdriver, detach the 3 clips.

      HINT:
      Tape the screwdriver tip before use.



  1. Large Type:



      B157878E01
    1. Using a screwdriver, detach the 3 clips and peel off the double-sided tape.

      HINT:
      Tape the screwdriver tip before use.

  1. Disconnect the center stop light connector and remove the rear spoiler.



7. REMOVE CENTER STOP LIGHT ASSEMBLY


    E071103E01
  1. Disconnect the connector.

  1. Tie a string around the center stop light assembly cord.



    E071102E01
  1. Remove the 2 screws and the center stop light assembly.

    NOTICE:
    The string will be used when installing, so leave the string as it is inside the back door.