Home › BODY › EXTERIOR › FRONT DOOR BELT MOULDING

FRONT DOOR BELT MOULDING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH


    B132614
  1. Attach the claws to install the moulding.

    HINT:
    Confirm that the moulding is firmly installed.



2. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH


B075148E01
  1. Install the mirror with the 3 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.



3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


B075137E02
  1. Attach the 7 clips to install the trim board.

  1. Install the screw.



4. INSTALL FRONT ARMREST UPPER BASE PANEL LH
  1. for Driver's Side:
    Install the window regulator master switch to the armrest upper base panel with the 3 screws.

  1. Connect the switch connector.



    B075142E03
  1. Attach the 2 clips and 4 claws to install the armrest base panel (with the window regulator master switch).

  1. for Passenger's Side:
    Attach the 2 claws to install the power window regulator switch.

  1. Attach the 2 claws to install the door control switch.

  1. Connect the connector.



    B075143E03
  1. Attach the 2 clips and 4 claws to install the armrest upper base panel together with the 2 switches.



5. INSTALL DOOR PULL HANDLE


B075150E01
  1. Install the pull handle with the screw.



6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH


B076973E07
  1. Attach the 3 claws to install the bezel.



7. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH


B075149E02
  1. Attach the 2 clips to install the garnish.



8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


9. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.