Home › BODY › EXTERIOR › ROOF DRIP SIDE FINISH MOULDING

ROOF DRIP SIDE FINISH MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. REMOVE ROOF DRIP SIDE FINISH MOULDING LH


B074186E02
  1. Put protective tape around the edges of the moulding.

  1. Using a moulding remover, detach the moulding's front and rear end 2 clips and remove the moulding.

    NOTICE:
    1. Do not remove the clips from the vehicle body.
    2. If the clips are damaged or removed accidentally, replace them.