Home › BODY › EXTERIOR › REAR DOOR BELT MOULDING

REAR DOOR BELT MOULDING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH


    B132613
  1. Attach the claws to install the moulding.

    HINT:
    Confirm that the moulding is firmly installed.



2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B075164E03
  1. Attach the 7 clips and install the trim board.

  1. Install the screw.



3. INSTALL REAR DOOR ARMREST UPPER BASE PANEL LH


B075153E03


4. INSTALL DOOR PULL HANDLE


    B075150E01
  1. Install the pull handle with the screw.



5. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH


    B076973E07
  1. Attach the 3 claws to install the bezel.



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.