Home › BODY › EXTERIOR › REAR DOOR BELT MOULDING

REAR DOOR BELT MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH


    B076973E06
  1. Using a screwdriver, detach the 3 claws and remove the bezel.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE DOOR PULL HANDLE


    B075150E01
  1. Remove the screw and pull handle.



4. REMOVE REAR DOOR ARMREST UPPER BASE PANEL LH


B075153E03
  1. Using a screwdriver, detach the 2 claws and remove the power window regulator switch.

    HINT:
    Tape the screwdriver tip before use.

  1. Disconnect the switch connector.



5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH


    B075164E03
  1. Remove the screw.

  1. Using a screwdriver, detach the 7 clips and remove the trim board.

    HINT:
    1. In order to prevent the door panel from being damaged, use protective tape to cover the areas indicated by the arrow marks in the illustration.
    2. If the clip cannot be reached with the screwdriver, pull on the lower trim to remove it.



6. REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH


    B074179E02
  1. Put protective tape under the moulding.

  1. Using a moulding remover, detach the claws to remove the moulding as shown in the illustration.

    HINT:
    Tape the remover tip before use.